--- title: "Connect the cables for in-line mode" slug: "connect-the-cables-for-in-line-mode-1" tags: ["Hardware"] updated: 2026-09-17T10:37:47Z published: 2026-09-17T10:37:47Z canonical: "docs.trellix.com/connect-the-cables-for-in-line-mode-1" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Connect the cables for in-line mode In-line ethernet ports can be configured as fail-open or fail-closed. The RJ-45 monitoring ports have built-in fail-open functionality. The fiber monitoring ports have a built-in fail-open function on ports 11-14. However, they do not have the same function on ports 5-6. Ethernet ports fail-close, implying that the flow of traffic will stop if the Sensor fails. To allow traffic to flow uninterrupted, you may use an external active fail-open kit(s). You can also utilize our built-in fail-open functionality to avoid network disruptions if a Sensor encounters a very rare failure. For instructions, see the subsequent sections of this chapter. This section provides steps to connect the Sensor's ethernet ports so they fail-close. 1. Plug the cable into one of the monitoring ports. For example, 1. 2. Plug the cable into the other monitoring port. For example, 2. ![Sensor_InLine_mode.png](https://cdn.us.document360.io/0d453a50-e1da-4d4a-9409-fea7959614d8/Images/Documentation/uuid-fa612668-af56-49c2-8029-62536adeda25.png?sv=2026-02-06&spr=https&st=2026-11-20T07%3A50%3A05Z&se=2026-11-20T08%3A50%3A05Z&sr=c&sp=r&sig=vprap5xtfsse%2BdixibxNqxd86op0jBJf3TSbhAJ0sVs%3D) 3. Connect the other end of each cable to the network devices that you want to monitor. For example, if you plan to monitor traffic between a switch and a router, connect the cable connected to 1 to the router (3) and the one connected to 2 to the switch (4).