--- title: "Connect the cables for in-line mode" slug: "connect-the-cables-for-in-line-mode-5" tags: ["Hardware", "IPS 11.1.x"] updated: 2026-09-17T09:43:41Z published: 2026-09-17T09:43:41Z canonical: "docs.trellix.com/connect-the-cables-for-in-line-mode-5" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Connect the cables for in-line mode In-line Gigabit Ethernet ports can be configured as fail-open or fail-closed. The RJ-45 monitoring ports are built-in and include an built-in fail-open functionality as well. All other monitoring ports require the use of external active fail-open (AFO) kits for In-Line Fail-Open Active configuration. Gigabit Ethernet ports fail-close, means the flow of traffic will stop if the Sensor fails. To allow traffic to flow uninterrupted, you must use special hardware, and cable the Sensor to external active fail-open kits. For instructions, see the subsequent sections of this chapter. This section provides the steps to connect the Sensor's Gigabit Ethernet ports so they fail-close. **Steps:** 1. Plug the cable appropriate for use with your transceiver module into one of the Monitoring ports, for example G1/1. 2. Plug the cable appropriate for use with your transceiver module into one of the Monitoring ports, for example G1/2. ![GUID-67D79E21-4D74-4B58-9A36-8298ADA01DDD-low.png](https://cdn.us.document360.io/0d453a50-e1da-4d4a-9409-fea7959614d8/Images/Documentation/uuid-0db5cd36-46ea-04ab-59d6-431202d21ba2.png?sv=2026-02-06&spr=https&st=2026-11-20T10%3A16%3A40Z&se=2026-11-20T11%3A16%3A40Z&sr=c&sp=r&sig=iUwqSHVL3X9E76HdgmNQy5PTYTYPcfmDkoAanWM3jv0%3D) 3. Connect the other end of each cable to the network devices that you want to monitor. For example, if you plan to monitor traffic between a switch and a router, connect the cable connected to 1 to the router and the one connected to 2 to the switch.