--- title: "Connect the cables for in-line mode" slug: "connect-the-cables-for-in-line-mode-6" tags: ["Hardware", "IPS 11.1.x"] updated: 2026-09-17T09:43:45Z published: 2026-09-17T09:43:45Z canonical: "docs.trellix.com/connect-the-cables-for-in-line-mode-6" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Connect the cables for in-line mode In-line Gigabit Ethernet ports can be configured as fail-open or fail-closed. The RJ-45 monitoring ports are built-in and include an built-in fail-open functionality as well. All other monitoring ports require the use of either Trellix's 4-port 1/10 Gigabit Modular Passive Fail-Open kit or external active fail-open (AFO) kits for In-Line Fail-Open Active configuration. Gigabit Ethernet ports fail-close, means the flow of traffic will stop if the Sensor fails. To allow traffic to flow uninterrupted, you must use special hardware, and cable the Sensor to external active fail-open kits. For instructions, see the subsequent sections of this chapter. This section provides the steps to connect the Sensor's Gigabit Ethernet ports so they fail-close. 1. Plug the cable appropriate for use with your transceiver module into one of the Monitoring ports, for example G1/1. 2. Plug the cable appropriate for use with your transceiver module into one of the Monitoring ports, for example G1/2. 3. Connect the other end of each cable to the network devices that you want to monitor. For example, if you plan to monitor traffic between a switch and a router, connect the cable connected to 1 to the switch and the one connected to 2 to the router.