--- title: "Connect the cables for tap mode" slug: "connect-the-cables-for-tap-mode" tags: ["Hardware"] updated: 2026-09-17T10:17:59Z published: 2026-09-17T10:17:59Z canonical: "docs.trellix.com/connect-the-cables-for-tap-mode" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Connect the cables for tap mode To deploy the Sensor in tap mode, you must use a Sensor's Gigabit Ethernet Monitoring port pair with a third-party external tap. > [!NOTE] > Note > > For a list of Trellix-approved third party vendors, see the KnowledgeBase at [https://support.trellix.com](https://support.trellix.com). Enter the relevant KnowledgeBase article in **Search the Support Knowledge Center** and click **Search** to locate the relevant KnowledgeBase article. 1. Plug the cable appropriate for use with your transceiver module into one of the Monitoring ports, for example, G0/1. 2. Plug the cable appropriate for use with your transceiver module into one of the Monitoring ports, for example, G0/2. 3. Connect the other end of each cable to the tap. 4. Connect the network devices that you want to monitor to the tap.