--- title: "Connect the Fail-Open module to a Sensor" slug: "connect-the-fail-open-module-to-a-sensor" tags: ["Hardware", "IPS 11.1.x"] updated: 2026-09-17T07:33:43Z published: 2026-09-17T07:33:43Z canonical: "docs.trellix.com/connect-the-fail-open-module-to-a-sensor" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Connect the Fail-Open module to a Sensor Connecting the Fail-Open module involves the following: **Steps:** 1. Ear mount the Fail-Open module. 2. Based on the type of Fail-Open module, insert the transreceiver into the Fail-Open Module ports (**MON0** and **MON1**). - For 10G Fail-Open module, insert the SFP+ transreceiver (SR or LR) - For 40G Fail-Open module, insert the QSFP+ transceiver (BiDi, SR4, or LR4) 3. Plug an inside network cable connector (LC SM (10/40 G), LC MM (10/40 G), or MTP/MPO MM type) into the Network port labeled **NET0** on the Active Fail-Open module. 4. Plug the other end of this cable into the corresponding network device. 5. Plug an outside network cable into the Network port labeled **NET1** (LC SM (10/40 G), LC MM (10/40 G), or MTP/MPO MM type) on the Active Fail-Open module. 6. Plug the other end of this cable into the corresponding network device. 7. Plug a proper fiber cable (inside) into the monitoring port of the Sensor. 8. Plug the other end of the cable into the appliance port labeled **MON0** on the Active Fail-Open module. 9. Plug a proper fiber cable (outside) into the corresponding peer port. (For example, if you used 1 in step 1, plug the cable into port 2) 10. Plug the other end of the cable into the appliance port labeled **MON1** on the Active Fail-Open module. > [!NOTE] > Note > > With this cable configuration, Sensor monitoring port 1 views traffic as originating inside the network, and port 2 views traffic as originating outside the network. Note that this configuration (1 = outside, 2 = inside) must match the port configuration specified for this Sensor, and that the ports must be enabled. For more information on Port configuration accomplished via the Trellix IPS Manager, refer to *Trellix Intrusion Prevention System Product Guide*.