--- title: "Creating Network Security network interfaces" slug: "creating-network-security-network-interfaces" tags: ["Endpoint Security (HX)", "Product Usage"] updated: 2026-09-09T22:45:38Z published: 2026-09-09T22:45:38Z canonical: "docs.trellix.com/creating-network-security-network-interfaces" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Creating Network Security network interfaces The ether1 interface on the Network Security virtual machine is the only interface that Azure creates by default using the default Azure Marketplace listing. You must create the optional submission interface (ether2) and the monitoring interfaces (pether3, pether4, and so on), and then attach them to the virtual machine. (If your virtual machine was created using an ARM template, the ether1, ether2, pether3, and pether4 interfaces are already created for you.) You can optionally create two additional network interfaces (pether 5 and pether6) for instance sizes that support six interfaces. IP forwarding must be enabled on monitoring interfaces to ensure that all network traffic reaches the Network Security appliance. To create a network interface: 1. In the Azure portal, select **All services**, and then click **Network interfaces** under **Networking**. ![Azure_add_iface.png](https://cdn.us.document360.io/0d453a50-e1da-4d4a-9409-fea7959614d8/Images/Documentation/uuid-1aaf7001-17d8-c856-167a-2f51a251e4f5.png?sv=2026-02-06&spr=https&st=2026-11-20T10%3A16%3A07Z&se=2026-11-20T11%3A16%3A07Z&sr=c&sp=r&sig=a2Pdil%2FXnEFjerNS98bPITvmU%2Bry0YANhleXFupYW%2BM%3D) 2. Click **Add**. The **Create network interface** page opens. 3. Make sure the correct **Subscription** is selected. 4. Select the correct **Resource group**. 5. Enter a meaningful **Name** for the interface. 6. Make sure the correct **Region**, **Virtual network**, and **Subnet** are selected. ### Important Each interface must be in a separate subnet. 7. *Recommended*: Click **Static** and enter a static IP address to assign to the interface. Otherwise, select **Dynamic**. 8. Select the correct **Network security group**. 9. Select the **Private IP address (IPv6)** check box if the subnet uses IPv6 addresses. 10. Click **Next: Add tags** and specify name and value pairs for the tags to apply to the network interface. 11. Click **Review + create**. 12. Click **Create** after the validation passes and you confirm the information on the page. :