--- title: "Defining the interfaces using the CLI" slug: "defining-the-interfaces-using-the-cli" updated: 2026-08-24T20:40:08Z published: 2026-08-24T20:40:08Z canonical: "docs.trellix.com/defining-the-interfaces-using-the-cli" stale: true --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Defining the interfaces using the CLI Use the commands in this section to define the submission interface on a sensor or hybrid appliance and broker node, and to define the cluster interface on a broker node and compute node. > [!NOTE] > Note > > Alternatively, you can change the interfaces for a broker and node in the configuration wizard. Use the configuration jump-start command to start the wizard. **Defining the submission interface** ##### To define the submission interface on a sensor or hybrid appliance: 1. Log in to the sensor or hybrid appliance CLI. 2. Enable the CLI configuration mode: ``` hostname > enable hostname # configure terminal ``` 3. Specify the interface: ``` hostname (config) # mvx sensor config submission-if ``` 4. *If the sensor or hybrid appliance and broker are in different subnets*: Specify the IPv4 address of the default gateway for the interface: ``` hostname (config) # mvx sensor config submission-if default-gateway ipv4 ``` 5. Verify your change: ``` hostname (config) # show mvx status ``` 6. Save your change: ``` hostname (config) # write memory ``` ##### To define the submission interface on a broker node: 1. Log in to the broker (Virtual Execution) CLI. 2. Enable the CLI configuration mode ``` vx-hostname > enable vx-hostname # configure terminal ``` 3. Specify the interface name: ``` vx-hostname (config) # mvx node config submission-if ``` 4. *If the broker and any sensors are in different subnets*: Specify the IPv4 address of the default gateway for the interface: ``` vx-hostname (config) # mvx node config submission-if default-gateway ipv4 ``` 5. Verify your changes: ``` vx-hostname (config) # show mvx node status ``` 6. Save your changes: ``` vx-hostname (config) # write memory Defining the cluster interface ``` ##### To define the cluster interface on a broker node or compute node: 1. Log in to the Virtual Execution CLI. 2. Enable the CLI configuration mode: ``` vx-hostname > enable vx-hostname # configure terminal ``` 3. Specify the interface: ``` vx-hostname (config) # mvx node config cluster-if ``` 4. Verify your change: ``` vx-hostname (config) # show mvx node status ``` 5. Save your change: ``` vx-hostname (config) # write memory ``` **Examples** The following example defines ether2 as the cluster interface on the vx-3 node. ``` vx-3 (hostname) # mvx node config cluster-if ether2 vx-3 (hostname) # show mvx node status MVX Cluster: Node Status    Broker role:    Enabled                 : no    Ready:                  : yes    SSH port                : 22    Submission Interface    : ether1    Cluster Interface       : ether2    Key Hash                : f8:xx:xx:... ... The following example defines ether2 as the submission interface on the nx-4 sensor. nx-4 (hostname) # mvx node config submission-if ether2 nx-4 (hostname) # show mvx status MVX Mode Status: Sensor Config Enabled        : yes Current Operating Mode       : sensor Mode Reboot Required         : no Submission Interface         : ether2 Modes Supported              : mvx configurable ... ```