Use the commands in this section to delete a Network Security HA pair from the Central Management System appliance.
To delete a Network Security HA pair:
Log in to the Central Management System CLI.
Enable the CLI configuration mode:
hostname > enable hostname # configure terminal hostname (config) #
Delete the pair:
hostname (config) # no cmc ha nx <pair>
Verify your change:
hostname (config) # show cmc ha nx
Save your change:
hostname (config) # write memory
Example
The following example deletes the Acme_NXHA pair.
hostname (config) # no cmc ha nx Acme_NXHA hostname (config) # show cmc ha nx No NX-HA pairs configured.