--- title: "Deleting all rules from a network policy for SSL interception using the CLI" slug: "deleting-all-rules-from-a-network-policy-for-ssl-interception-using-the-cli" tags: ["Product Usage", "EX 11.x", "FX 11.x", "AX 11.x", "NX 11.x", "Network Security"] updated: 2026-09-12T20:42:40Z published: 2026-09-12T20:42:40Z canonical: "docs.trellix.com/deleting-all-rules-from-a-network-policy-for-ssl-interception-using-the-cli" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Deleting all rules from a network policy for SSL interception using the CLI Use the commands in this section to delete all the rules from a network policy that are based on the destination IPv4 or IPv6 address, source IPv4 or IPv6 address, or mask. **To delete all the rules from a network policy:** 1. Go to CLI configuration mode. ``` hostname > enable hostname # configure terminal ``` 2. Delete all the rules from a network policy. ``` hostname (config) # no policymgr ssl-intercept network all ``` 3. Verify the status of the network policy rules configuration for SSL interception. ``` hostname (config) # show policymgr ssl-intercept network Total CIDR Rule Supported: 512 Total CIDR Rule Configured: 0 INTF    IP                     ACTION ``` The "Total CIDR Rule Configured" line displays the value of 0 if all the rules are deleted from a network policy. 4. Save your changes. ``` hostname (config) # write memory ```