--- title: "Deleting an entry from the SmartVision alerts whitelist using the CLI" slug: "deleting-an-entry-from-the-smartvision-alerts-whitelist-using-the-cli" tags: ["Network Security (NX)", "Product Usage"] updated: 2026-09-02T17:27:05Z published: 2026-09-02T17:27:05Z canonical: "docs.trellix.com/deleting-an-entry-from-the-smartvision-alerts-whitelist-using-the-cli" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Deleting an entry from the SmartVision alerts whitelist using the CLI If alerts are triggered by valid traffic, you can add a combination of conditions for whitelisting SmartVision alerts. ### Prerequisites - Admin access to the SmartVision appliance. To remove a combination of conditions from the alerts whitelist: 1. Log in to the appliance CLI and go to configuration mode: ``` hostname > enable hostname # configure terminal ``` 2. View the alerts whitelist. In this example, the list contains a single entry that combines a SmartVision rule ID and an IPv4 source address block. ``` hostname (config) # show smartvision alert whitelist SmartVision Alert Whitelist Config Rule        Source Prefix         Dest Prefix           Type 91500002    192.168.4.0/24        -                     rule-source ``` 3. Remove a combination of conditions to the alerts whitelist by using the `no smartvision alert whitelist` command. This example removes the entry from the SmartVision alerts whitelist: ``` hostname (config) # no smartvision alert whitelist rule 91500002 source 192.168.4.0/24 ``` 4. Verify the change. ``` hostname # show smartvision alert whitelist SmartVision Alert Whitelist Config Rule        Source Prefix         Dest Prefix           Type ``` 5. Save your changes. ``` hostname (config) #  write memory ``` :