--- title: "Deploying virtual Network Security appliances using Hyper-V Manager in inline mode" slug: "deploying-virtual-network-security-appliances-using-hyper-v-manager-inline-mode" tags: ["Endpoint Security (HX)", "Product Usage"] updated: 2026-09-09T22:45:38Z published: 2026-09-09T22:45:38Z canonical: "docs.trellix.com/deploying-virtual-network-security-appliances-using-hyper-v-manager-inline-mode" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Deploying virtual Network Security appliances using Hyper-V Manager in inline mode In a typical Network Security inline deployment, port pair A is the inline port pair. The pether3 monitoring interface is connected to the subnet that hosts the on-premises enterprise clients (the client subnet) and the pether4 monitoring interface is connected to a subnet that hosts the Network Security appliance (the server subnet). Example addresses for the subnets and interfaces are shown below.Example addresses for the subnets and interfaces are shown below. - Client subnet—**10.100.1.64/27** - Network Security pether3 interface—**10.100.1.69** - Server subnet—**10.100.1.96/27** - Network Security pether4 interface—**10.100.1.100** ### Note This procedure assumes that the interface pair The following task is required to configure a virtual Network Security appliance in inline mode. No additional tasks are required in Hyper-V Manager. - Use the policymgr layer3-mode enable command in the Network Security CLI to enable Layer 3 forwarding. For detailed information and additional commands, see the "Layer 3 Forwarding Using VRF Instances" information in the Network Security System Administration Guide. :