This command explicitly starts a network deployment check. If no monitoring interfaces are up, network deployment checking cannot start.
For more information, see the Network Security System Administration Guide.
Note
You can also run this command remotely from the command line of an integrated Trellix Central Management System appliance using the Central Management System appliance proxying mechanism.
Syntax
deployment check network start
Parameters
None
Examples
The following example explicitly starts a network deployment check on a Network Security appliance.
hostname (config) # deployment check network start
The following example explicitly starts a network deployment check on a Network Security appliance on which the previous deployment check has not completed.
hostname # deployment check network start All dataport link down. Deployment check could not be started.
The following example, executed on a Central Management System appliance, starts a network deployment check on the managed Network Security appliance named NX‑1.
hostname # cmc execute appliance NX-1 command "deployment check network start"
User role
Admin, Operator, Monitor or Analyst
Command mode
Enable
Supported appliances
This command is supported on the following appliances running the specified releases or later:
Network Security:Release 7.4.0.