--- title: "Deployment of Sensors in tap mode" slug: "deployment-of-sensors-in-tap-mode" tags: ["Product Usage", "IPS 10.1.10"] updated: 2026-09-06T12:28:01Z published: 2026-10-05T15:41:20Z canonical: "docs.trellix.com/deployment-of-sensors-in-tap-mode" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Deployment of Sensors in tap mode A *tap*--internal or external--is a passive wiring device that copies traffic on full-duplex Ethernet segments, and sends this copied traffic information to the S processors for analysis. Full-duplex taps split a link into separate transmit and receive channels. Sensors provide multiple monitoring interfaces to monitor the two channels, and Sensor ports are wired in pairs in order to accommodate full-duplex taps. Two monitoring ports are used to monitor one full-duplex link using a tap. The benefits to using Sensors in tap mode are: - **Monitor uplinks passively** -- Taps cause no latency in your network traffic. You essentially sniff traffic as it passes. - **No need for SPAN ports** -- On most switches, the SPAN port operates in half-duplex mode, so the maximum bandwidth a Fast Ethernet port can handle is 100 Mbps before it begins dropping packets. If the uplink is running at more than 100Mbps aggregate, a Fast Ethernet SPAN port can't handle it; a full-duplex tap can. Another issue is that there are a limited number of SPAN ports supported on most switches, and there is typically a lot of competition for them (for example, for RMON probes, sniffers, etc.). - **Traffic continues to flow if the tap fails** -- Completely passive and fault tolerant, taps provide fail-safe operation with no impact on network connectivity or performance. Taps *fail open*, meaning that a failed Sensor permits traffic to continue to flow unimpeded. The downside of tap mode is that, unlike in-line mode, you cannot prevent attacks. Tap mode is passive; the Sensor essentially sees malicious traffic as it passes, so sensing an attack in tap mode triggers a response post-attack. You also cannot inject response packets back through a tap; the Sensor provides Response ports to inject response packets. Tap mode ![Tap mode](https://cdn.us.document360.io/0d453a50-e1da-4d4a-9409-fea7959614d8/Images/Documentation/GUID-CA9EFBCA-AA85-4F29-83CC-CEA770AFAB12-low(1).png?sv=2026-02-06&spr=https&st=2026-11-20T11%3A08%3A55Z&se=2026-11-20T12%3A08%3A55Z&sr=c&sp=r&sig=SGazJeoSlqQh6rNoyl64xLVXdnWxZF9ApsWUWY8nhms%3D)