--- title: "Deployment scenario" slug: "deployment-scenario-2" tags: ["Product Usage", "IPS 11.1.x"] updated: 2026-11-19T12:31:15Z published: 2026-11-19T12:31:15Z canonical: "docs.trellix.com/deployment-scenario-2" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Deployment scenario Since we have looked at the steps to set up a fail-open switch and deploy it, we’ll go through a scenario to see how the setup works. We will cover configuration steps at a high level without listing each step. For more detailed steps on any section, refer to sections above. The deployment uses the following software and hardware equipment: - 100G - QSFP28- SR4 50 µm optical active fail-open switch - NS9500 model with standard 100 Gigabit QSFP28 monitoring ports - Windows or Linux system installed with a MIB browser, such as iReasoning - Cables for connecting various devices - Terminal emulation software such as HyperTerminal or PuTTy. We will be using PuTTy for this deployment - Make note of these parameters that you will while setting up fail-open switch parameters. - Baud rate: 115200 bits per second - Data bits: 8 - Parity: None - Stop bits: 1 - Flow Control: XON/XOFF - Username and password: `Trellix00` - Fail-open switch MIBs to decode SNMP traps from a 100G active fail-open switch. If you do not have MIBs with you, contact Technical Support.