Disabling access groups for alerts using the CLI

Use the commands in this topic to disable the use of access groups for alerts.

To disable access groups for alerts:

Go to CLI configuration mode:

cm-hostname > enable
cm-hostname # configure terminal

Disable the access group for alerts feature:

cm-hostname (config) # no aaa authorization access-groups area alerts enable

Verify your change:

cm-hostname (config) # show aaa authorization access-groups

Save your change:
```
cm-hostname (config) # write memory
```

Example

The following example disables access groups for alerts on the cm-05 appliance. The nx-alerts access group is not removed, but has no effect unless access groups for alerts are re-enabled.

cm-05 (config) # no aaa authorization access-groups area alerts enable

cm-05 (config) # show aaa authorization access-groups
AAA Access-groups enabled for : none

----------------------------------------------
# Group: nx-alerts   
----------------------------------------------
# Rule           Statements
----------------------------------------------
#1               Not Match Alert Severity: minor
...