--- title: "Disabling data exfiltration detection using the CLI" slug: "disabling-data-exfiltration-detection-using-the-cli" tags: ["Network Security (NX)", "Product Usage"] updated: 2026-09-02T17:27:09Z published: 2026-09-02T17:27:09Z canonical: "docs.trellix.com/disabling-data-exfiltration-detection-using-the-cli" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Disabling data exfiltration detection using the CLI Follow these steps to disable data theft detection. ### Prerequisites - Admin access to the SmartVision appliance. To disable data exfiltration detection: 1. Log in to the appliance CLI and go to configuration mode: ``` hostname > enable hostname # configure terminal ``` 2. Disable data exfiltration detection on the appliance. ``` hostname (config) # no smartvision exfil ``` 3. Verify your configuration change. ``` hostname (config) # show smartvision status SmartVision State        Detection                      : no        Context Service                : running        Data exfil detection state     : unmanaged        Beaconing detection state      : unmanaged        TLS detection state            : unmanaged              .              .              . ``` ``` hostname (config) # show smartvision config SmartVision Config        Detection Enabled             : yes        Context Service enabled       : yes        SC Killswitch                 : noData exfil detection enabled  : yes        Beaconing detection enabled   : no        TLS detection enabled         : no        Base version                  : 2        Rule version                  : 3              .              .              . ``` 4. Save your changes. ``` hostname (config) #  write memory ``` :