--- title: "DoS filter management" slug: "dos-filter-management" tags: ["Product Usage", "IPS 10.1.10"] updated: 2026-10-05T15:39:53Z published: 2026-10-05T15:39:53Z canonical: "docs.trellix.com/dos-filter-management" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # DoS filter management You can view and modify the drop/block packets responses that have been initiated for the DoS learning mode profiles applied for all network identifiers (NIs) within a Sensor. A DoS filter, or blocking rule, is similar to a firewall deny rule in that subsequent traffic that matches the filter parameters is blocked from transmitting further through your network. A network identifier is a Trellix IPS term relating to interface, subinterface, and DoS ID resources. DoS filters are applied exclusively to DoS learning mode attacks. A DoS filter can be initiated for any DoS learning mode attack, namely the measures within each attack. Each enabled learning mode attack is a combination of traffic flow rate measures, such as the rate of TCP control packets or UDP packets. When a learning mode profile has completed learning the normal traffic behavior, the long-term measure volumes in this profile are matched against short-term volume calculations for each measure. If the short-term volume is outside of the long-term volume, a statistical attack type alert is raised. Once a statistical alert has been raised, the Sensor can initiate an automatic or manual response to block all subsequent packets of the violated measure. - For automatic dropping and blocking, you configure a DoS policy with the *drop packets* response enabled for one or more measures and apply the policy to a Sensor interface in inline mode. Automatic filters last as long as the short-term volume continues to violate the long-term volume. - For manual blocking, you must initiate the response from IPS Policies for an attack. For more information, see Blocking DoS attacks. ## Task 1. Click the **Devices** tab. 2. Select the domain from the **Domain** drop-down list. 3. In the left pane, click the **Devices** tab. 4. Select the device from the **Device** drop-down list. 5. Select **Troubleshooting** → **Denial of Service** → **Filters**. Do one of the following: - To delete a filter, select a filter and click **Delete**. - To refresh a filter, select a filter and click **Refresh**. - To extend a filter, do the following: 1. Select a filter and click **Extend**. The **Add DoS Filter Time** dialog opens. 2. Type the number of seconds to add to the **Filter Time**. 3. Click **Save**; click **Cancel** to abort. Add DoS Filter ![](https://cdn.us.document360.io/0d453a50-e1da-4d4a-9409-fea7959614d8/Images/Documentation/GUID-30F684F6-D5F2-4ECD-A64A-AF5222F427E3-low.png?sv=2026-02-06&spr=https&st=2026-11-20T13%3A50%3A39Z&se=2026-11-20T14%3A50%3A39Z&sr=c&sp=r&sig=NRtwIdMaSZwDbITAhntJ0IWNtEzXJ1e4HWm%2F8p37PPc%3D)