--- title: "(Either) Connect a copper fail-open switch" slug: "either-connect-a-copper-fail-open-switch" tags: ["Hardware", "IPS 11.1.x"] updated: 2026-09-17T07:33:43Z published: 2026-09-17T07:33:43Z canonical: "docs.trellix.com/either-connect-a-copper-fail-open-switch" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # (Either) Connect a copper fail-open switch **Prerequisites:** - You will require two Cat 5/Cat 5e Ethernet cables to connect your fail-open switch to the Sensor. - You will require two copper SFPs to be inserted into two corresponding blank ports on the Sensor. > [!TIP] > Tip > > For more details about your Sensor, refer to the *Trellix Intrusion Prevention System NS-series Sensor Product Guide* for the appropriate model. **Steps:** 1. Connect a Cat 5/Cat 5e Ethernet cable (inside) into the copper SFP in port **Gy/a** or **xA**, where **y** represents the module number (for NS-Series Sensors), and **x** and **a** represent port numbers. 2. Connect the other end of the cable to the labeled **Mon 0** on the fail-open switch. 3. Connect a Cat 5/Cat 5e Ethernet cable (outside) to the corresponding **Gy/b** or **xB** peer port. (For example, if you used **G1/1** in step 1, plug the cable into port **G1/2**). 4. Connect the other end of the cable to the labeled **Mon 1** of the bypass switch. **Result:** With this cable configuration, Sensor monitoring port **Gy/a** or **xA** views traffic as originating inside the network, and port **Gy/b** or **xB** views traffic as emerging outside the network. This configuration (**Gy/a** or **xA** = outside, **Gy/b** or **xB** = inside) must match the port configuration specified for this Sensor, and that the ports must be configured accordingly.