--- title: "Enable IP address spoofing detection" slug: "enable-ip-address-spoofing-detection-2" tags: ["Product Usage", "IPS 11.1.x"] updated: 2026-11-19T12:26:19Z published: 2026-11-19T12:26:19Z canonical: "docs.trellix.com/enable-ip-address-spoofing-detection-2" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Enable IP address spoofing detection **Prerequisite:** Make sure that for the port-pairs for which you need to enable Anti-spoofing feature, their **Mode** is set to inline and their **Interface Type** is set to CIDR. 1. Click the **Devices** tab. 2. Select the domain from the **Domain** drop-down list. 3. On the left pane, click the **Devices** tab. 4. Select the device from the **Device** drop-down list. 5. Select **Setup** → **Advanced** → **Anti-Spoofing**. The **Anti-Spoofing** page displays. Note that the tabs relate to the interfaces on the Sensor. 6. For the required port-pairs, enable **Anti-Spoofing** in the required directions - inbound, outbound, or both. You can only enable IP spoofing detection for port-pairs in inline mode with CIDR interface types. CIDR entries must be previously configured for IP spoofing detection to function properly. You can enable Anti-spoofing at the interface level; you cannot enable it for specific CIDR subinterfaces. > [!NOTE] > Note > > You can click an interface name to view the CIDRs configured for that interface. **Configuring Anti-spoofing**![Configuring Anti-spoofing](https://cdn.us.document360.io/0d453a50-e1da-4d4a-9409-fea7959614d8/Images/Documentation/uuid-cb5b5625-87f3-22cc-3edb-7ecbc973bf33(7).png?sv=2026-02-06&spr=https&st=2026-11-20T08%3A44%3A11Z&se=2026-11-20T09%3A44%3A11Z&sr=c&sp=r&sig=nIWMRMHfpdVGt3DbIlp74qMkOuXtjlBpaGSapPuReGs%3D) 7. Click **Save** to enable IP spoofing detection. Once you click **Save**, the configuration is sent through SNMP to the Sensor; thus, you do not have to update the configuration changes to the Sensor. > [!NOTE] > Note > > When you enable Anti-spoofing, a Sensor drops any IP-spoofed packets but raises no alert. You can view a list of dropped packets by clicking on the **Dropped Packets** tab in **Devices** → **** → **Devices** → **** → **Troubleshooting** → **Traffic Statistics**. Once in the tab, select the port for which you want to see the list and count of dropped packets. > > Alternatively, you can use the `show inlinepktdropstat`Sensor CLI command to view the number of IP-spoofed packets dropped by a Sensor. For information on using this CLI, refer to the CLI commands section.