--- title: "Enable IP address spoofing detection" slug: "enable-ip-address-spoofing-detection" tags: ["Product Usage", "IPS 10.1.10"] updated: 2026-10-05T15:40:51Z published: 2026-10-05T15:40:51Z canonical: "docs.trellix.com/enable-ip-address-spoofing-detection" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Enable IP address spoofing detection ## Before you begin Make sure that for the port-pairs for which you need to enable Anti-spoofing feature, their **Mode** is set to inline and their **Interface Type** is set to CIDR. ## Task 1. Click the **Devices** tab. 2. Select the domain from the **Domain** drop-down list. 3. On the left pane, click the **Devices** tab. 4. Select the device from the **Device** drop-down list. 5. Select **Setup** → **Advanced** → **Anti-Spoofing**. The **Anti-Spoofing** page displays. Note that the tabs relate to the interfaces on the Sensor. 6. For the required port-pairs, enable **Anti-Spoofing** in the required directions - inbound, outbound, or both. You can only enable IP spoofing detection for port-pairs in inline mode with CIDR interface types. CIDR entries must be previously configured for IP spoofing detection to function properly. You can enable Anti-spoofing at the interface level; you cannot enable it for specific CIDR subinterfaces. > [!NOTE] > Note > > You can click an interface name to view the CIDRs configured for that interface. Configuring Anti-spoofing ![](https://cdn.us.document360.io/0d453a50-e1da-4d4a-9409-fea7959614d8/Images/Documentation/GUID-C118C12C-466C-4633-9C93-AF8E7663F7A9-low.png?sv=2026-02-06&spr=https&st=2026-11-22T15%3A06%3A45Z&se=2026-11-22T16%3A06%3A45Z&sr=c&sp=r&sig=bdHakiVUp5UGbzyscBLzpCW3WNvG9JQ8bv%2BHsuT2vwU%3D) 7. Click **Save** to enable IP spoofing detection. Once you click **Save**, the configuration is sent through SNMP to the Sensor; thus, you do not have to update the configuration changes to the Sensor. > [!NOTE] > Note > > When you enable Anti-spoofing, a Sensor drops any IP-spoofed packets but raises no alert. You can view a list of dropped packets by clicking on the **Dropped Packets** tab in **Devices** → **** → **Devices** → **** → **Troubleshooting** → **Traffic Statistics**. Once in the tab, select the port for which you want to see the list and count of dropped packets. > > Alternatively, you can use the show inlinepktdropstat Sensor CLI command to view the number of IP-spoofed packets dropped by a Sensor. For information on using this CLI, refer to the CLI commands section.