--- title: "Enable Layer 2 Assert Mode" slug: "enable-layer-2-assert-mode-2" tags: ["Product Usage", "IPS 11.1.x"] updated: 2026-11-19T12:29:40Z published: 2026-11-19T12:29:40Z canonical: "docs.trellix.com/enable-layer-2-assert-mode-2" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Enable Layer 2 Assert Mode The changes made on the Manager interface are also reflected on Sensor CLI. To view the status on the Sensor, enter `status` command. **Steps:** 1. To enable the **Assert** mode, click **Devices** → **** → **Devices** → **** → **Troubleshooting** → **Layer 2 Bypass**. 2. In the **Layer 2 Pass-Through Monitoring** section, select **Assert** in the drop-down list against **Layer 2 Mode**. 3. Check **ARP Spoofing** to enable it on the device. 4. Click **Save**. Once applied, you can view the number of critical faults and current mode in the **Layer 2 Pass-Through Status** dialog at the bottom of the screen. **Layer 2 Settings window**![Layer 2 Settings window](https://cdn.us.document360.io/0d453a50-e1da-4d4a-9409-fea7959614d8/Images/Documentation/uuid-505e308f-15e8-a91d-24e5-39d78f0d94cb(7).jpg?sv=2026-02-06&spr=https&st=2026-11-20T09%3A12%3A10Z&se=2026-11-20T10%3A12%3A10Z&sr=c&sp=r&sig=VbWSoA8rbO%2Fwd4F5M8vBK2qTL2L3A%2Ba0WcVHQizAORk%3D) Note the following status fields: - **Occurrences**: Displays the current number of threshold-breaching events - **Current Mode**: Displays the current mode of the device. **Abnormal** means that Layer 2 pass-through mode is enabled in the device. **L2 Pass-Through Mode** means pass-through mode is enabled. > [!NOTE] > Note > > To view the status of **Assert** mode for Sensors in a stack, Click **Devices** → **** → **Devices** → **** → **Member Sensors** → **** → **Troubleshooting** → **Layer 2 Bypass** > [!NOTE] > Note > > - The Manager interface does not allow you to move to **ON/OFF** mode once the layer 2 mode is set to **Assert**, then only **Deassert** is allowed. > - If you set the mode to **'Assert'**, it gets applied to all the Member Sensors for a stack / HA. > - The Layer 2 modes **Assert/Dessert** could only be set from Manager interface for Sensor versions 10.1.5.107 and above. For others, it is recommended to set these modes through CLI commands.