--- title: "Enable Layer 2 Deassert Mode" slug: "enable-layer-2-deassert-mode-2" tags: ["Product Usage", "IPS 11.1.x"] updated: 2026-11-19T12:29:40Z published: 2026-11-19T12:29:40Z canonical: "docs.trellix.com/enable-layer-2-deassert-mode-2" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Enable Layer 2 Deassert Mode The changes made on the Manager interface are also reflected on Sensor CLI. To view the status on the Sensor, enter `status` command. **Steps:** 1. To enable the **Deassert** mode, click **Devices** → **** → **Devices** → **** → **Troubleshooting** → **Layer 2 Bypass**. 2. In the **Layer 2 Pass-Through Monitoring** section, select **Deassert** in the drop-down list against **Layer 2 Mode**. > [!NOTE] > Note > > The **Deassert** mode is displayed only if layer 2 mode is previously set to **Assert** mode. 3. Check **ARP Spoofing** to enable it on the device. 4. Click **Save**. Once applied, you can view the number of critical faults and current mode in the **Layer 2 Pass-Through Status** dialog at the bottom of the screen. **Layer 2 Settings window**![Layer 2 Settings window](https://cdn.us.document360.io/0d453a50-e1da-4d4a-9409-fea7959614d8/Images/Documentation/uuid-65e3ab6a-8e50-5641-8b42-fdbfc31821ef(7).jpg?sv=2026-02-06&spr=https&st=2026-11-20T09%3A12%3A11Z&se=2026-11-20T10%3A12%3A11Z&sr=c&sp=r&sig=UjUJSdAJci6ARjo5O9EhUF87EXqTzu4ug6h6GufbqG0%3D) Note the following status fields: - **Occurrences**: Displays the current number of threshold-breaching events - **Current Mode**: Displays the current mode of the device. **Normal** means that layer 2 pass-through mode is not enabled in the device. **L2 Pass-Through Mode** means pass-through mode is enabled. > [!NOTE] > Note > > To view the status of **Deassert** mode for Sensors in a stack, Click **Devices** → **** → **Devices** → **** → **Member Sensors** → **** → **Troubleshooting** → **Layer 2 Bypass** > [!NOTE] > Note > > The Manager interface does not allow you to move to **Deassert** mode when the layer 2 mode is set to **ON/OFF**.