---
title: "Enable Layer 2 Deassert Mode"
slug: "enable-layer-2-deassert-mode"
tags: ["Product Usage", "IPS 10.1.10"]
updated: 2026-10-05T15:40:03Z
published: 2026-10-05T15:40:03Z
canonical: "docs.trellix.com/enable-layer-2-deassert-mode"
---
> ## Documentation Index
> Fetch the complete documentation index at: https://docs.trellix.com/llms.txt
> Use this file to discover all available pages before exploring further.
# Enable Layer 2 Deassert Mode
The changes made on the Manager interface are also reflected on Sensor CLI. To view the status on the Sensor, enter status command.
## Task
1. To enable the
**Deassert** mode, click
**Devices** → **** → **Devices** → **** → **Troubleshooting** → **Layer 2 Bypass**.
2. In the
**Layer 2 Pass-Through Monitoring** section, select
**Deassert** in the drop-down list against
**Layer 2 Mode**.
> [!NOTE]
> Note
>
> The **Deassert** mode is displayed only if layer 2 mode is previously set to **Assert** mode.
3. Check
**ARP Spoofing** to enable it on the device.
4. Click
**Save**.
Once applied, you can view the number of critical faults and current mode in the **Layer 2 Pass-Through Status** dialog at the bottom of the screen.
Layer 2 Settings window

Note the following status fields:
- **Occurrences**: Displays the current number of threshold-breaching events
- **Current Mode**: Displays the current mode of the device.
**Normal** means that layer 2 pass-through mode is not enabled in the device.
**L2 Pass-Through Mode** means pass-through mode is enabled.
> [!NOTE]
> Note
>
> To view the status of **Deassert** mode for Sensors in a stack, Click **Devices** → **** → **Devices** → **** → **Member Sensors** → **** → **Troubleshooting** → **Layer 2 Bypass**
> [!NOTE]
> Note
>
> The Manager interface does not allow you to move to **Deassert** mode when the layer 2 mode is set to **ON/OFF**.