--- title: "Enable or disable a monitoring port" slug: "enable-or-disable-a-monitoring-port" tags: ["Product Usage", "IPS 10.1.10"] updated: 2026-10-05T15:41:11Z published: 2026-10-05T15:41:11Z canonical: "docs.trellix.com/enable-or-disable-a-monitoring-port" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Enable or disable a monitoring port This section explains about enabling and disabling a monitoring port from the **Monitoring Ports** tab. To view or configure the settings of the monitoring ports for Trellix IPS, you access the configuration page in **Devices** → **** → **Devices** → **** → **Setup** → **Physical Ports**. A list of ports available for the device you selected are displayed on the **Monitoring Ports** tab of a new page. To disable a monitoring port: 1. Click on the row of the monitoring port that you wish to disable. > [!NOTE] > Note > > - To disable multiple monitoring ports, press the > **Ctrl** key and click on multiple monitoring ports that you wish to disable. > - Since monitoring ports are internally wired, when you disable one of the ports in a pair, the corresponding port is also disabled. 2. Click on the **Disable** button. The monitoring port(s) are disabled. To enable a monitoring port: 1. Click on the row of the monitoring port that you wish to enable. > [!NOTE] > Note > > To enable multiple monitoring ports, press the **Ctrl** key and click on multiple monitoring ports that you wish to enable. 2. Click on the **Enable** button. The monitoring port(s) are enabled. > [!NOTE] > Note > > The configurations made to the monitoring port will not be pushed to the Sensor automatically when the port is in **Disable** state. Trellix recommends you to perform **Deploy Pending Changes** immediately after changing the port status.