--- title: "Enable tap/bypass mode for the Active Fail-Open module" slug: "enable-tap-bypass-mode-for-the-active-fail-open-module-2" tags: ["Product Usage", "IPS 11.1.x"] updated: 2026-11-19T12:26:19Z published: 2026-11-19T12:26:19Z canonical: "docs.trellix.com/enable-tap-bypass-mode-for-the-active-fail-open-module-2" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Enable tap/bypass mode for the Active Fail-Open module **Prerequisites:** - Configure an IPv4 address for your Active Fail-Open chassis. - Make sure you can access the Active Fail-Open web interface using a web browser. You can enable tap mode for your Active Fail-Open module if you use a tap to route network traffic to the Sensor monitoring ports. 1. Log on to the web interface of the Active Fail-Open module. Use default credentials to access the web interface. 2. Go to, **AFO Configuration** → **Module ** to access the configuration page. 3. Under **Heartbeat Setting**, deselect **Heartbeat Active Mode**. 4. Under **Active OP Mode**, select **TAP/Bypass** from the drop-down list. ![GUID-B4F7C4AC-6619-4CD4-B6B6-64C05FF1F23F-low.jpg](https://cdn.us.document360.io/0d453a50-e1da-4d4a-9409-fea7959614d8/Images/Documentation/uuid-e5d927a3-5747-04f2-5239-851bdc761055(7).jpg?sv=2026-02-06&spr=https&st=2026-11-20T13%3A31%3A39Z&se=2026-11-20T14%3A31%3A39Z&sr=c&sp=r&sig=EOBUG6NEJ5pCmPQGbPhfyE93ru%2FQacv2rQl1fKE20KU%3D) 5. Click **Commit** to save your configuration. You have set your Active Fail-Open to tap/bypass mode of operation. > [!NOTE] > Note > > To return to inline mode, > > 1. Under **Heartbeat Setting**, select **Heartbeat Active Mode**. > 2. Click **Commit** to save your configuration. > 3. Click **Save** to retain the changes across active fail-open chassis reboot.