--- title: "Enable tap/inline mode for the Active Fail-Open module" slug: "enable-tap-inline-mode-for-the-active-fail-open-module" tags: ["Product Usage", "IPS 10.1.10"] updated: 2026-10-05T15:41:16Z published: 2026-10-05T15:41:16Z canonical: "docs.trellix.com/enable-tap-inline-mode-for-the-active-fail-open-module" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Enable tap/inline mode for the Active Fail-Open module ## Before you begin - Configure an IPv4 address for your Active Fail-Open chassis. - Make sure you can access the Active Fail-Open web interface using a web browser. You can enable tap mode for your Active Fail-Open module if you use a tap to route network traffic to the Sensor monitoring ports. ## Task 1. Login to the web interface of the Active Fail-Open module. Use default credentials to access the web interface. 2. Click the **Bypass** tab to access the **Bypass** configuration page. 3. Under **HB active mode**, select **Off** from the drop-down list. 4. Under **Active bypass**, select **tap/inline** from the drop-down list. ![](https://cdn.us.document360.io/0d453a50-e1da-4d4a-9409-fea7959614d8/Images/Documentation/GUID-3B3248FE-C7F8-4F4F-B791-165E1B1F4135-low.jpg?sv=2026-02-06&spr=https&st=2026-11-22T22%3A55%3A24Z&se=2026-11-22T23%3A55%3A24Z&sr=c&sp=r&sig=PkyM9p01vAEU%2BxZnk5wys%2B10PcTST3h2u3fxeDKFW1Y%3D) 5. Click **Apply** to save your configuration. ## Results You have set your Active Fail-Open to tap/inline mode of operation. > [!NOTE] > Note > > To return to Bypass mode, > > 1. under > **HB active mode**, select > **on** from the drop-down list. > 2. Click > **Apply** to save your configuration.