--- title: "Enable tap mode for the fail-open switch" slug: "enable-tap-mode-for-the-fail-open-switch-2" tags: ["Hardware", "IPS 11.1.x"] updated: 2026-08-19T18:44:24Z published: 2026-09-17T07:33:47Z canonical: "docs.trellix.com/enable-tap-mode-for-the-fail-open-switch-2" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Enable tap mode for the fail-open switch **Prerequisites:** - Configure an IPv4 address for your fail-open switch. - Make sure you can access the fail-open switch web interface using a web browser. You can enable tap mode for your active fail-open switch if you use a tap to route network traffic to the Sensor Monitoring ports. **Steps:** 1. Log on to the web interface of the active fail-open switch. Use default credentials to access the web interface. For more information about the web interface, refer to the section [Access the fail-open switch web interface](/network-and-platform/docs/manage-the-fail-open-switch-through-a-web-interface). 2. Click the **Bypass** tab to access the **Bypass** configuration page. 3. Click the **HB active mode** drop-down menu and select **Off**. 4. In the **Active bypass** section, select **tap**. ![GUID-E12A9934-0E2E-4962-972D-1CA3CEDC9D97-low.jpg](https://cdn.us.document360.io/0d453a50-e1da-4d4a-9409-fea7959614d8/Images/Documentation/uuid-2e69e8e7-79e6-ffcd-eda5-c3d973a20872(1).jpg?sv=2026-02-06&spr=https&st=2026-11-20T18%3A09%3A23Z&se=2026-11-20T19%3A09%3A23Z&sr=c&sp=r&sig=0Cjl9ogquYEDzBgNDWyjfn2QbUEHzHybe4TOhj7%2BjuI%3D) 5. Click **Apply** to save your configuration. **Result:** You have set your active fail-open to tap mode of operation.