Prerequisites:
Configure an IPv4 address for your fail-open switch.
Make sure you are able to access the fail-open switch web-interface using a web browser.
You can enable tap mode for your fail-open switch if you use a tap to route network traffic to the Sensor monitoring ports.
Log on to the web interface of the fail-open switch.
Use default credentials to access the web interface.
Click the Bypass tab to access the Bypass configuration page.
Under HB active mode, select Off from the drop-down list.
Under Active bypass, select tap from the drop-down list.
.jpg?sv=2026-02-06&spr=https&st=2026-11-20T12%3A38%3A55Z&se=2026-11-20T12%3A49%3A55Z&sr=c&sp=r&sig=7Cn%2F5YoJKQYIHhITdB3f2RVIEJIp5xH%2FKV%2Bmv%2BeUCPg%3D)
Click Apply to save your configuration.
You have set your fail-open switch to tap mode of operation.