--- title: "Enable tap mode for the fail-open switch" slug: "enable-tap-mode-for-the-fail-open-switch-4" tags: ["Product Usage", "IPS 11.1.x"] updated: 2026-11-19T12:29:02Z published: 2026-11-19T12:29:02Z canonical: "docs.trellix.com/enable-tap-mode-for-the-fail-open-switch-4" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Enable tap mode for the fail-open switch **Prerequisites:** - Configure an IPv4 address for your fail-open switch. - Make sure you are able to access the fail-open switch web-interface using a web browser. You can enable tap mode for your fail-open switch if you use a tap to route network traffic to the Sensor monitoring ports. 1. Log on to the web interface of the fail-open switch. Use default credentials to access the web interface. 2. Click the **Bypass** tab to access the **Bypass** configuration page. 3. Under **HB active mode**, select **Off** from the drop-down list. 4. Under **Active bypass**, select **tap** from the drop-down list. ![GUID-E12A9934-0E2E-4962-972D-1CA3CEDC9D97-low.jpg](https://cdn.us.document360.io/0d453a50-e1da-4d4a-9409-fea7959614d8/Images/Documentation/uuid-2e69e8e7-79e6-ffcd-eda5-c3d973a20872(8).jpg?sv=2026-02-06&spr=https&st=2026-11-20T12%3A44%3A54Z&se=2026-11-20T13%3A44%3A54Z&sr=c&sp=r&sig=xAZO7wfjlJdKhylTauiOW%2Bnjqg7UKEiN%2BAsI2Sp35zc%3D) 5. Click **Apply** to save your configuration. You have set your fail-open switch to tap mode of operation.