Use the commands in this topic to enable a BA signer.
Note
Only previously disabled BA signers can be enabled again.
To enable a BA signer:
Enable the CLI configuration mode.
hostname > enable hostname # configure terminal
Switch to the insecure signer mode.
hostname (config) # signer-whitelist mode insecure
Verify that you have switched to the insecure mode.
hostname (config) # show signer-whitelist mode BA signer mode: insecure
Enable BA signer 11.
hostname (config) # signer-whitelist enable number
Where number is the index number of the signer in the whitelist.
Save your changes.
hostname (config) # write memory