--- title: "Enabling a BA signer using the CLI" slug: "enabling-a-ba-signer-using-the-cli" tags: ["Product Usage", "EX 11.x", "FX 11.x", "AX 11.x", "NX 11.x", "Network Security"] updated: 2026-09-12T20:42:26Z published: 2026-09-12T20:42:26Z canonical: "docs.trellix.com/enabling-a-ba-signer-using-the-cli" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Enabling a BA signer using the CLI Use the commands in this topic to enable a BA signer. > [!NOTE] > Note > > Only previously disabled BA signers can be enabled again. **To enable a BA signer:** 1. Enable the CLI configuration mode. ``` hostname > enable hostname # configure terminal ``` 2. Switch to the insecure signer mode. ``` hostname (config) # signer-whitelist mode insecure ``` 3. Verify that you have switched to the insecure mode. ``` hostname (config) # show signer-whitelist mode BA signer mode: insecure ``` 4. Enable BA signer 11. ``` hostname (config) # signer-whitelist enable number ``` Where *number* is the index number of the signer in the whitelist. 5. Save your changes. ``` hostname (config) # write memory ```