Use the Network Security appliance CLI to enable and disable frontend loopback.
Prerequisites
Admin or Operator access to the Network Security appliance.
To enable the frontend loopback troubleshooting functionality:
Log in to the appliance CLI and go to configuration mode:
hostname > enable hostname # configure terminal
Enable frontend loopback:
hostname (config) # fedp loopback frontend enable
Confirm your change:
hostname (config) # show fedp loopback status
To disable the frontend loopback troubleshooting functionality:
Log in to the appliance CLI and go to configuration mode:
hostname > enable hostname # configure terminal
Disable the frontend loopback:
hostname (config) # no fedp loopback frontend enable
Confirm your change:
hostname (config) # show fedp loopback status