Use the Network Security appliance CLI to enable and disable inline engine loopback.
Prerequisites
Admin or Operator access to the Network Security appliance.
To enable the inline engine loopback troubleshooting functionality:
Log in to the appliance CLI and go to configuration mode:
hostname > enable hostname # configure terminal
Enable inline engine loopback:
hostname (config) # fedp loopback inline_engine enable
Confirm your change:
hostname (config) # show fedp loopback status
To disable the inline engine loopback troubleshooting functionality:
Log in to the appliance CLI and go to configuration mode:
hostname > enable hostname # configure terminal
Disable the inline engine loopback:
hostname (config) # no fedp loopback inline_engine enable
Confirm your change:
hostname (config) # show fedp loopback status