--- title: "Enabling and disabling inline engine loopback using the CLI" slug: "enabling-and-disabling-inline-engine-loopback-using-the-cli" tags: ["Product Usage", "EX 11.x", "FX 11.x", "AX 11.x", "NX 11.x", "Network Security"] updated: 2026-09-12T20:42:40Z published: 2026-09-12T20:42:40Z canonical: "docs.trellix.com/enabling-and-disabling-inline-engine-loopback-using-the-cli" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Enabling and disabling inline engine loopback using the CLI Use the Network Security appliance CLI to enable and disable inline engine loopback. ### Prerequisites - Admin or Operator access to the Network Security appliance. **To enable the inline engine loopback troubleshooting functionality:** 1. Log in to the appliance CLI and go to configuration mode: ``` hostname > enable hostname # configure terminal ``` 2. Enable inline engine loopback: ``` hostname (config) # fedp loopback inline_engine enable ``` 3. Confirm your change: ``` hostname (config) # show fedp loopback status ``` **To disable the inline engine loopback troubleshooting functionality:** 1. Log in to the appliance CLI and go to configuration mode: ``` hostname > enable hostname # configure terminal ``` 2. Disable the inline engine loopback: ``` hostname (config) # no fedp loopback inline_engine enable ``` 3. Confirm your change: ``` hostname (config) # show fedp loopback status ```