Enabling or disabling advanced URL defense using the CLI

Follow these steps to enable or disable the Advanced URL Defense feature using the CLI.

Important
When the Central Management System appliance is used to manage your Network Security appliances, use one of the following configuration commands to enable Advanced URL Defense:
cmc execute appliance <appliance_name> command "analysis url policy adv-url-defense enable"
cmc execute group <group_name> command "analysis url policy adv-url-defense enable"
The Central Management System appliance will apply the setting globally to all qualified Network Security appliances that are connected or will be connected to that Central Management System appliance.

Note
In Release 8.0, do not use the show email-analysis policy command to verify the status for Advanced URL Defense.

To enable Advanced URL Defense:

Go to CLI configuration mode:

hostname > enable
hostname # configure terminal

Enable the settings for Advanced URL Defense.
```
hostname (config) # analysis url policy adv-url-defense enable
```
Note
In Release 8.0, the email-analysis policy adv-url-defense enable command was changed to the analysis url policy adv-url-defense enable command.
Save your changes.
```
hostname (config) # write memory
```

Verify the status for Advanced URL Defense.

hostname (config) # show analysis url-policy
 . 
 .
 Advanced URL Defense: yes

To disable Advanced URL Defense:

Go to CLI configuration mode:

hostname > enable
hostname # configure terminal

Disable Advanced URL Defense.
```
hostname (config) # no analysis url policy adv-url-defense enable
```
Note
In Release 8.0, the no email-analysis policy adv-url-defense enable command was changed to the no analysis url policy adv-url-defense enable command.
Save your changes.
```
hostname (config) # write memory
```

Verify the status for Advanced URL Defense.

hostname (config) # show analysis url-policy
 .
 .
 Advanced URL Defense: no