ATI is automatically enabled on a Network Security appliance when you install an All sharing CONTENT_UPDATES license with ATI support. ATI is automatically disabled if you remove or downgrade the license.
Note
For managed Network Security appliances, you configure ATI settings from the CLI of the Central Management System
Central Management System appliance.
Prerequisites
Log in to the Network Security CLI with a user account that is associated with Admin or Analyst access.
To enable ATI:
Enter CLI configuration mode.
hostname > enable hostname # configure terminal hostname (config) #
Enable ATI on the appliance.
hostname (config) # ati enable
Verify the ATI status.
hostname (config) # show ati status ATI license status : enabled ATI status : enabled ATI auto update status : enabled
To disable ATI:
Enter CLI configuration mode.
hostname > enable hostname # configure terminal hostname (config) #
Disable ATI on the appliance.
hostname (config) # no ati enable
Verify the ATI status.
hostname (config) # show ati status ATI status : disabled