--- title: "Enabling or disabling ATI using the CLI" slug: "enabling-or-disabling-ati-using-the-cli" tags: ["Product Usage", "EX 11.x", "FX 11.x", "AX 11.x", "NX 11.x", "Network Security"] updated: 2026-09-12T20:42:23Z published: 2026-09-12T20:42:23Z canonical: "docs.trellix.com/enabling-or-disabling-ati-using-the-cli" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Enabling or disabling ATI using the CLI ATI is automatically enabled on a Network Security appliance when you install an All sharing CONTENT_UPDATES license with ATI support. ATI is automatically disabled if you remove or downgrade the license. > [!NOTE] > Note > > For managed Network Security appliances, you configure ATI settings from the CLI of the Central Management System > > Central Management System appliance. Prerequisites - Log in to the Network Security CLI with a user account that is associated with Admin or Analyst access. **To enable ATI:** 1. Enter CLI configuration mode. ``` hostname > enable hostname # configure terminal hostname (config) # ``` 2. Enable ATI on the appliance. ``` hostname (config) # ati enable ``` 3. Verify the ATI status. ``` hostname (config) # show ati status ATI license status : enabled ATI status : enabled ATI auto update status : enabled ``` **To disable ATI:** 1. Enter CLI configuration mode. ``` hostname > enable hostname # configure terminal hostname (config) # ``` 2. Disable ATI on the appliance. ``` hostname (config) # no ati enable ``` 3. Verify the ATI status. ``` hostname (config) # show ati status ATI status : disabled ```