Enabling or disabling AV-Check using the CLI

Follow these steps to enable or disable AV-Check to perform static analysis on the File Protect appliance.

To enable AV-Check:

Enable the CLI configuration mode.

hostname > enable
hostname # configure terminal

Enable AV-Check to perform static analysis on the appliance.
```
hostname (config) # static-analysis av-check enable
```

Verify that AV-Check is enabled to perform static analysis on the appliance.

hostname (config) # show static-analysis config

Static Analysis enabled                   : yes
  AV-suite enabled                        : yes
  SA on AV-suite whitelist enabled        : no
  AV-check enabled                       : yes
  Dropper enabled                         : yes
  YARA enabled                            : yes
  .....

To disable AV-Check:

Enable the CLI configuration mode.

hostname > enable
hostname # configure terminal

Disable AV-Check.

hostname (config) # no static-analysis av-check enable

Verify that AV-Check is disabled.

hostname (config) # show static-analysis config

Static Analysis enabled                   : yes
  AV-suite enabled                        : yes
  SA on AV-suite whitelist enabled        : no
  AV-check enabled                       : no
  Dropper enabled                         : yes
  YARA enabled                            : yes
  .....