--- title: "Enabling or disabling AV-Check using the CLI" slug: "enabling-or-disabling-av-check-using-the-cli-1" updated: 2026-09-08T21:45:37Z published: 2026-09-08T21:45:37Z canonical: "docs.trellix.com/enabling-or-disabling-av-check-using-the-cli-1" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Enabling or disabling AV-Check using the CLI Follow these steps to enable or disable AV-Check to perform static analysis on the File Protect appliance. To enable AV-Check: 1. Enable the CLI configuration mode. ``` hostname > enable hostname # configure terminal ``` 2. Enable AV-Check to perform static analysis on the appliance. ``` hostname (config) # static-analysis av-check enable ``` 3. Verify that AV-Check is enabled to perform static analysis on the appliance. ``` hostname (config) # show static-analysis config ``` ``` Static Analysis enabled                   : yes  AV-suite enabled                        : yes  SA on AV-suite whitelist enabled        : no  AV-check enabled                       : yes  Dropper enabled                         : yes  YARA enabled                            : yes  ..... ``` To disable AV-Check: 1. Enable the CLI configuration mode. ``` hostname > enable hostname # configure terminal ``` 2. Disable AV-Check. ``` hostname (config) # no static-analysis av-check enable ``` 3. Verify that AV-Check is disabled. ``` hostname (config) # show static-analysis config ``` ``` Static Analysis enabled                   : yes  AV-suite enabled                        : yes  SA on AV-suite whitelist enabled        : no  AV-check enabled                       : no  Dropper enabled                         : yes  YARA enabled                            : yes  ..... ``` :