--- title: "Enabling or disabling blocked-by-proxy detection using the CLI" slug: "enabling-or-disabling-blocked-by-proxy-detection-using-the-cli" tags: ["Product Usage", "EX 11.x", "FX 11.x", "AX 11.x", "NX 11.x", "Network Security"] updated: 2026-09-12T20:42:33Z published: 2026-09-12T20:42:33Z canonical: "docs.trellix.com/enabling-or-disabling-blocked-by-proxy-detection-using-the-cli" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Enabling or disabling blocked-by-proxy detection using the CLI Follow these steps to enable or disable blocked-by-proxy detection using the CLI. The feature is disabled by default. ### Prerequisites - Admin access to the Network Security appliance CLI. **To enable or disable blocked-by-proxy detection:** 1. Go to CLI configuration mode. ``` hostname > enable hostname # configure terminal ``` 2. To enable blocked-by-proxy detection, use the following command: ``` hostname (config) # swg scan block-by-proxy enable ``` 3. To disable blocked-by-proxy detection, use the “no” form of the command: ``` hostname (config) # no swg scan block-by-proxy enable ``` 4. Verify your changes. ``` hostname (config) # show swg config hostname (config) # show fenotify preferences bbo ``` 5. Save your changes. ``` hostname (config) # write memory ```