--- title: "Enabling or disabling dropper detection using the CLI" slug: "enabling-or-disabling-dropper-detection-using-the-cli" updated: 2026-09-08T23:22:51Z published: 2026-09-08T23:22:51Z canonical: "docs.trellix.com/enabling-or-disabling-dropper-detection-using-the-cli" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Enabling or disabling dropper detection using the CLI Follow these steps to enable or disable the dropper detection component to perform static analysis on the File Protect appliance. To enable dropper detection: 1. Enable the CLI configuration mode. ``` hostname > enable hostname # configure terminal ``` 2. Enable the dropper detection component to perform static analysis on the appliance. ``` hostname (config) # static-analysis dropper enable ``` 3. Verify that the dropper detection component can perform static analysis on the appliance. ``` hostname (config) # show static-analysis config ``` ``` Static Analysis enabled                   : yes  AV-suite enabled                        : yes  SA on AV-suite whitelist enabled        : no  AV-check enabled                        : yes  Dropper enabled                        : yes  YARA enabled                            : yes  ..... ``` To disable dropper detection: 1. Enable the CLI configuration mode. ``` hostname > enable hostname # configure terminal ``` 2. Disable dropper detection. ``` hostname (config) # no static-analysis dropper enable ``` 3. Verify that dropper detection is disabled. ``` hostname (config) # show static-analysis config ``` ``` Static Analysis enabled                   : yes  AV-suite enabled                        : yes  SA on AV-suite whitelist enabled        : no  AV-check enabled                        : yes  Dropper enabled                        : no  YARA enabled                            : yes  ..... ``` :