Enabling or disabling ICAP request and response modification modes using the CLI

To enable or disable ICAP REQMOD support or ICAP RESPMOD support using the appliance CLI, use the [no] icap-service reqmod enable command or the [no] icap-service respmod enable command.

Prerequisites

Administrator access to the Network Security appliance

To enable ICAP REQMOD or RESPMOD support:

Go to CLI configuration mode.

hostname > enable
hostname # configure terminal

Enable REQMOD for the ICAP service on the appliance.
```
hostname (config) # icap-service reqmod enable
```
Enable RESPMOD for the ICAP service on the appliance.
```
hostname (config) # icap-service respmod enable
```

Verify the status of REQMOD and RESPMOD for the ICAP service.

hostname (config) # show icap-service config
ICAP Configuration:
  ICAP enabled             :  yes
  Interface                :  ether1
  Request Mod Enabled      :  yes
  Response Mod Enabled     :  yes
    .
    .
    .

The "Request Mod Enabled" and "Response Mod Enabled" lines display "yes" if the modes are enabled for the ICAP service.

Save your changes.
```
hostname (config) # write memory
```

To disable ICAP REQMOD or RESPMOD support:

Go to CLI configuration mode.

hostname > enable
hostname # configure terminal

Disable REQMOD for the ICAP service on the appliance.
```
hostname (config) # no icap-service reqmod enable
```
Disable RESPMOD for the ICAP service on the appliance.
```
hostname (config) # no icap-service respmod enable
```

Verify the status of REQMOD and RESPMOD for the ICAP service.

hostname (config) # show icap-service config
ICAP Configuration:
  ICAP enabled             :  yes
  Interface                :  ether1
  Request Mod Enabled      :  no
  Response Mod Enabled     :  no
    .
    .
    .

The "Request Mod Enabled" and "Response Mod Enabled" lines display "no" if the modes are disabled for the ICAP service.

Save your changes.
```
hostname (config) # write memory
```