--- title: "Enabling or disabling ICAP request and response modification modes using the CLI" slug: "enabling-or-disabling-icap-request-and-response-modification-modes-using-the-cli" tags: ["Product Usage", "EX 11.x", "FX 11.x", "AX 11.x", "NX 11.x", "Network Security"] updated: 2026-09-12T20:42:26Z published: 2026-09-12T20:42:26Z canonical: "docs.trellix.com/enabling-or-disabling-icap-request-and-response-modification-modes-using-the-cli" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Enabling or disabling ICAP request and response modification modes using the CLI To enable or disable ICAP REQMOD support or ICAP RESPMOD support using the appliance CLI, use the **[no] icap-service reqmod enable** command or the **[no] icap-service respmod enable** command. Prerequisites - Administrator access to the Network Security appliance **To enable ICAP REQMOD or RESPMOD support:** 1. Go to CLI configuration mode. ``` hostname > enable hostname # configure terminal ``` 2. Enable REQMOD for the ICAP service on the appliance. ``` hostname (config) # icap-service reqmod enable ``` 3. Enable RESPMOD for the ICAP service on the appliance. ``` hostname (config) # icap-service respmod enable ``` 4. Verify the status of REQMOD and RESPMOD for the ICAP service. ``` hostname (config) # show icap-service config ICAP Configuration:  ICAP enabled             :  yes  Interface                :  ether1  Request Mod Enabled      :  yes  Response Mod Enabled     :  yes    .    .    . ``` The "Request Mod Enabled" and "Response Mod Enabled" lines display "yes" if the modes are enabled for the ICAP service. 5. Save your changes. ``` hostname (config) # write memory ``` **To disable ICAP REQMOD or RESPMOD support:** 1. Go to CLI configuration mode. ``` hostname > enable hostname # configure terminal ``` 2. Disable REQMOD for the ICAP service on the appliance. ``` hostname (config) # no icap-service reqmod enable ``` 3. Disable RESPMOD for the ICAP service on the appliance. ``` hostname (config) # no icap-service respmod enable ``` 4. Verify the status of REQMOD and RESPMOD for the ICAP service. ``` hostname (config) # show icap-service config ICAP Configuration:  ICAP enabled             :  yes  Interface                :  ether1  Request Mod Enabled      :  no  Response Mod Enabled     :  no    .    .    . ``` The "Request Mod Enabled" and "Response Mod Enabled" lines display "no" if the modes are disabled for the ICAP service. 5. Save your changes. ``` hostname (config) # write memory ```