--- title: "Enabling or disabling retroactive detection from AV-Suite using the CLI" slug: "enabling-or-disabling-retroactive-detection-from-av-suite-using-the-cli-1" updated: 2026-09-08T23:22:51Z published: 2026-09-08T23:22:51Z canonical: "docs.trellix.com/enabling-or-disabling-retroactive-detection-from-av-suite-using-the-cli-1" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Enabling or disabling retroactive detection from AV-Suite using the CLI Follow these steps to enable or disable retroactive detection from AV-Suite using the CLI. To enable retroactive detection from AV-Suite: 1. Go to CLI configuration mode: ``` hostname > enable hostname # configure terminal ``` 2. Enable retroactive detection. ``` hostname (config) analysis retro-hunt enable ``` 3. Save your changes. ``` hostname (config) # write memory ``` 4. Verify the status for retroactive detection. ``` hostname (config) # show analysis config ..... Retroactive hunting : Enabled ..... ``` The "Retroactive hunting" line displays "Enabled" to indicate that the File Protect appliance can access the previous results of the analysis that were stored in AV-Suite. To disable retroactive detection from AV-Suite: 1. Go to CLI configuration mode: ``` hostname > enable hostname # configure terminal ``` 2. Disable retroactive detection. ``` hostname (config) # no analysis retro-hunt enable ``` 3. Save your changes. ``` hostname (config) # write memory ``` 4. Verify the status for retroactive detection. ``` hostname (config) show analysis config ...... Retroactive hunting : Disabled ..... ``` The "Retroactive hunting" line displays "Disabled" to indicate that theFile Protect appliance cannot access the previous results of the analysis that were stored in AV-Suite. :