--- title: "Enabling or disabling riskware detection using the CLI" slug: "enabling-or-disabling-riskware-detection-using-the-cli-1" tags: ["Product Usage", "FX 10.x", "AX 10.x", "NX 10.x", "Customer", "Network Security"] updated: 2026-09-07T21:29:17Z published: 2026-09-07T21:29:17Z canonical: "docs.trellix.com/enabling-or-disabling-riskware-detection-using-the-cli-1" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Enabling or disabling riskware detection using the CLI Use the CLI commands in this procedure to enable or disable riskware detection on the Malware Analysis appliance. **To enable riskware detection:** 1. Go to CLI configuration mode. ``` hostname > enable hostname # configure terminal ``` 2. Enable riskware detection on the appliance. ``` hostname (config) # analysis riskware enable ``` 3. Save your changes. ``` hostname (config) # write memory ``` 4. Verify the status of riskware detection. ``` . . . Riskware detection : Enabled ``` **To disable riskware detection:** 1. Go to CLI configuration mode. ``` hostname > enable hostname # configure terminal ``` 2. Disable riskware detection on the appliance. ``` hostname (config) # no analysis riskware enable ``` 3. Save your changes. ``` hostname (config) # write memory ``` 4. Verify the status of riskware detection. ``` hostname (config) # show analysis config . . . Riskware detection : Disabled ```