--- title: "Enabling or disabling static analysis using the CLI" slug: "enabling-or-disabling-static-analysis-using-the-cli-4" tags: ["Product Usage", "EX 11.x", "FX 11.x", "AX 11.x", "NX 11.x", "Customer", "Network Security"] updated: 2026-09-07T21:14:23Z published: 2026-09-07T21:14:23Z canonical: "docs.trellix.com/enabling-or-disabling-static-analysis-using-the-cli-4" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Enabling or disabling static analysis using the CLI Follow these steps to enable or disable static analysis on the Malware Analysis appliance. **To enable static analysis:** 1. Enter the CLI configuration mode: ``` hostname > enable hostname # configure terminal ``` 2. Enable static analysis on the appliance. ``` hostname (config) # static-analysis enable ``` 3. Verify the status that static analysis is enabled on the appliance. ``` hostname (config) # show static-analysis config ``` ``` Static Analysis enabled                  : yes  AV-suite enabled                        : yes  SA on AV-suite whitelist enabled        : no  AV-check enabled                        : yes  Dropper enabled                         : yes  YARA enabled                            : yes  ..... ``` **To disable static analysis:** 1. Enter the CLI configuration mode: ``` hostname > enable hostname # configure terminal ``` 2. Disable static analysis on the appliance. ``` hostname (config) # no static-analysis enable ``` 3. Verify the status that static analysis is disabled on the appliance. ``` hostname (config) # show static-analysis config ``` ``` Static Analysis enabled                  : no  AV-suite enabled                        : yes  SA on AV-suite whitelist enabled        : no  AV-check enabled                        : yes  Dropper enabled                         : yes  YARA enabled                            : yes  ..... ```