--- title: "Enabling or disabling the Communications Broker Sender using the CLI" slug: "enabling-or-disabling-the-communications-broker-sender-using-the-cli" tags: ["Product Usage", "EX 11.x", "FX 11.x", "AX 11.x", "NX 11.x", "Network Security"] updated: 2026-09-12T20:42:26Z published: 2026-09-12T20:42:26Z canonical: "docs.trellix.com/enabling-or-disabling-the-communications-broker-sender-using-the-cli" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Enabling or disabling the Communications Broker Sender using the CLI Use the CLI commands to enable or disable the Communications Broker Sender. **To enable the Communications Broker Sender:** 1. Go to CLI configuration mode. ``` hostname > enable hostname # configure terminal ``` 2. Enable the Comm Broker on the appliance. ``` hostname (config) # commbroker enable ``` If the Comm Broker is enabled to receive and send third-party logs to Helix Enterprise on the Network Security appliance, the following message appears: `Enabling commbroker` 3. Verify the status of the Comm Broker. ``` hostname (config) # show commbroker status Commbroker status        State:    Enable        Running Status:    Running        Platform support:    Supported ``` **To disable Communications Broker Sender:** 1. Go to CLI configuration mode. ``` hostname > enable hostname # configure terminal ``` 2. Disable the Comm Broker on the appliance. ``` hostname (config) # no commbroker enable ``` If the Comm Broker is disabled, the following message appears: ``` Disabling commbroker ``` 3. Verify the status of the Comm Broker. ``` hostname (config) # show commbroker status Commbroker status        State:    Disable        Running Status:    Not Running        Platform support:    Supported ```