--- title: "Enabling or disabling the Evidence Collector module using the CLI" slug: "enabling-or-disabling-the-evidence-collector-module-using-the-cli" tags: ["Product Usage", "EX 11.x", "FX 11.x", "AX 11.x", "NX 11.x", "Network Security"] updated: 2026-09-12T20:42:26Z published: 2026-09-12T20:42:26Z canonical: "docs.trellix.com/enabling-or-disabling-the-evidence-collector-module-using-the-cli" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Enabling or disabling the Evidence Collector module using the CLI Use the CLI commands in this topic to enable or disable the Evidence Collector module using the CLI. **To enable the Evidence Collector module:** 1. Go to CLI configuration mode. ``` hostname > enable ``` ``` hostname # configure terminal ``` 2. Enable the Evidence Collector module on the appliance. ``` hostname (config) # tapsender enable ``` If the Evidence Collector module is enabled, the following message appears: ``` Enable tapsender Changes might take a few seconds to take effect. Use the CLI show tapsender status to check the status. ``` 3. Verify the status of the Evidence Collector module. ``` hostname (config) # show tapsender status ``` ``` Tapsender status  State:                            Enabled  Platform support:                 Supported ``` **To disable the Evidence Collector module:** 1. Go to CLI configuration mode. ``` hostname > enable ``` ``` hostname # configure terminal ``` 2. Disable the Evidence Collector module on the appliance. ``` hostname (config) # no tapsender enable ``` If the Evidence Collector module is disabled, the following message appears: ``` Disable tapsender ``` 3. Verify the status of the Evidence Collector module. ``` hostname (config) # show tapsender status ``` ``` Tapsender status   State:                            Disabled   Platform support:                 Supported ```