--- title: "Enabling or disabling the ICAP blocking comfort page using the CLI" slug: "enabling-or-disabling-the-icap-blocking-comfort-page-using-the-cli" tags: ["Product Usage", "EX 11.x", "FX 11.x", "AX 11.x", "NX 11.x", "Network Security"] updated: 2026-09-12T20:42:23Z published: 2026-09-12T20:42:23Z canonical: "docs.trellix.com/enabling-or-disabling-the-icap-blocking-comfort-page-using-the-cli" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Enabling or disabling the ICAP blocking comfort page using the CLI To enable or disable the ICAP blocking comfort page on a Network Security appliance using the CLI, use the `[no] icap-service block-mode response-page enable` command. Prerequisites - Administrator access to the Network Security appliance **To enable the ICAP blocking comfort page:** 1. Go to CLI configuration mode. ``` hostname > enable hostname # configure terminal ``` 2. Enable the ICAP blocking comfort page. ``` hostname (config) # icap-service block-mode response-page enable ``` 3. Verify the status of the ICAP blocking comfort page. ``` hostname (config) # show icap-service config ICAP Configuration:  ICAP enabled               :  yes  Interface                  :  ether1  Request Mod Enabled        :  yes  Response Mod Enabled       :  yes  Block-mode Enabled         :  yes  Response-page Enabled      :  yes    .    .    . ``` The "Response-page Enabled" line displays "yes" if the IICAP blocking comfort page is enabled for ICAP blocking. 4. Save your changes. ``` hostname (config) # write memory ``` **To disable ICAP blocking comfort page:** 1. Go to CLI configuration mode. ``` hostname > enable hostname # configure terminal ``` 2. Disable the ICAP blocking comfort page. ``` hostname (config) # no icap-service block-mode response-page enable ``` 3. Verify the status of the ICAP blocking comfort page. ``` hostname (config) # show icap-service config ICAP Configuration:  ICAP enabled               :  yes  Interface                  :  ether1  Request Mod Enabled        :  yes  Response Mod Enabled       :  yes  Block-mode Enabled         :  no  Response-page Enabled      :  no    .    .    . ``` The "Response-page Enabled" line displays "no" if the ICAP blocking comfort page is disabled for ICAP blocking. 4. Save your changes. ``` hostname (config) # write memory ```