--- title: "Enabling or disabling the proxy connection to cloud storage using the CLI" slug: "enabling-or-disabling-the-proxy-connection-to-cloud-storage-using-the-cli-1" updated: 2026-09-08T21:44:57Z published: 2026-09-08T21:44:57Z canonical: "docs.trellix.com/enabling-or-disabling-the-proxy-connection-to-cloud-storage-using-the-cli-1" --- > ## Documentation Index > Fetch the complete documentation index at: https://docs.trellix.com/llms.txt > Use this file to discover all available pages before exploring further. # Enabling or disabling the proxy connection to cloud storage using the CLI Use the commands in this procedure to enable or disable the proxy connection configured on your File Protect appliance to connect to cloud storage. ###### Prerequisites - An established connection between the File Protect appliance and the Internet. - Administrator or Operator access to the File Protect appliance. To enable the proxy connection: 1. Go to CLI configuration mode. ``` hostname > enable hostname # configure terminal ``` 2. Enable the proxy connection. ``` hostname (config) # fmps proxy enable ``` 3. Verify your configuration. ``` hostname (config) # show fmps proxy ``` ``` Proxy Config: Enabled  : yes FQDN     : 1.2.3.4 Port     : 80 Username : Password : ******** ``` To disable the proxy connection: 1. Go to CLI configuration mode. ``` hostname > enable hostname # configure terminal ``` 2. Disable the proxy connection. ``` hostname (config) # no fmps proxy enable ``` 3. Verify your configuration. ``` hostname (config) # show fmps proxy ``` ``` Proxy Config: Enabled  : no FQDN     : 1.2.3.4 Port     : 80 Username : Password : ******** ``` :